Repair Controllers

Relevant to EXT Gen 2 - Pico Neo 2
If one or more controllers are unpaired - a UI popup will appear prompting the user to repair controllers.

Disconnected.png
If the user looks at the ‘Re-pair controller’ UI button, it will take them to the controller settings. 

  1. Navigate to ‘Controller’ (Second from the top, under WiFi)
    mceclip1.png

  2. Navigate to ‘Controller Configuration’
    mceclip2.png

  3. Select 'Unbind'
    mceclip3.png
  4. Confirm that you want to unbind controllers
    mceclip4.png

  5. Select 'Add Controller'
    mceclip5.png

  6. The headset will now show that it is searching for controllers. On each controller hold down the 'Menu' and 'Trigger buttons' for 4 seconds to turn on pairing mode.

  7. Both the controllers should now be connected to the headset.

  8. Press home on either controller to return to FLAIM software.

Note. After unbinding controllers you will need to use the headsets gaze controls to navigate the menus. Look at button and aim with the small green circle. Press the side button to confirm selection. 

mceclip0.png


Avoid holding menu & trigger at the same time - this is what causes controllers to unpair. 

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section